This author has yet to write their bio.
Meanwhile lets just say that we are proud administrator contributed a whooping 307 entries.
Yellowing is to decompose and transform about 25% of protein, degrade more than 85% of chlorophyll, decompose and transform about 60% of starch, and lose 30-40% of water.
Relevant technicians of Shuntec Machinery said that after the dewaxing process of wolfberry is completed, it is gradually raised from 35°C to 60°C, and the drying can be completed in about 22 hours.
It is necessary to turn on the dryer in advance for preheating. When the preheating reaches 60C, put the lotus seeds that have been taken out of the lotus heart into it.
Shuntec drying heat pump has been successfully applied in 38 drying categories, accumulated 100 engineering cases, and accumulated drying technology experience in 72 industries.
Push it into the dryer to start drying, pay attention to the temperature is not too high, medium temperature is more suitable, usually, the initial temperature is about 50℃-55℃.
When drying in a drying room, a multi-layer rack should be set up to place the raw materials, the temperature should reach 32℃-42℃, and the water should be discharged.
The color-fixing stage should be done well. When the drying temperature reaches 42 °C, the leaves are all yellow, and when the drying temperature reaches 48 °C, the veins are all yellow.
Coal sludge is highly humid and highly adhesive, so it is tough to dry without drying it. After drying, peat can be used as fuel, but in addition to being used as fuel, it can also be used as raw material for production.
When using the heat pump unit, users should not cut off the power supply unless it is a last resort. Cutting off the power supply may cause damage to the heat pump unit.
The DC inverter compressor adopts a 6-pole medium coil motor and rare earth permanent magnets. The motor is small in size and high in efficiency.
Mob:+86 19924354377
Email: jason@shuntecdrying.com
